EUROPE PARTS / WATER BALANCE

How much fresh water do you need?

Set your sand feed rate, removed fines and product moisture. See how much water can be recirculated and how much fresh make-up water is needed.

Your process inputs


t/h

Dry mass of sand entering the washer.

1 t/h500 t/h

%

Percentage of the dry sand feed separated into sludge.

0%50%

%

Water retained in the product, as a percentage of the wet sand mass.

0%50%

Operating conditions & assumptions

m³/t

The water-to-sand ratio stays constant when you change the feed rate.

%

Solids as a percentage of total sludge mass. More concentrated sludge carries less water out of the circuit.

h/day

Fresh make-up water

7.00m³/h
56.00 m³/day
156 L/t
Where the wash water goes55.00 m³/h
Recovered and recirculated48.00 m³/h
Leaving with sand4.90 m³/h
Leaving with sludge2.10 m³/h

Make-up water required7.00 m³/h


Request plant sizing

Copy the summary and include it in your quotation request.

Water-balance estimate, not a guaranteed consumption figure. Excludes initial filling, water entering with the feed, additional drainage recovery and other losses. Plant sizing must be confirmed for the actual material and operating conditions.

Why do fines and moisture matter?

Fresh water replaces water leaving the circuit with sand and sludge. More removed fines or wetter product can increase the make-up water requirement.

Is recirculated flow the fresh-water consumption?

No. Part of the wash water returns to the process. The calculator separates recirculated flow from the fresh water needed to replenish the circuit.

Enable JavaScript to use the interactive calculator.